We will come to your address and carry out a diagnostic for the reported faults of no windows or lights and door locking not working
If we find no communication with the FRM we will remove and reprogram it then refit and test it all for £149 plus mileage
If we find no communication with the FRM we will remove and reprogram it then refit and test it all for £149 plus mileage
E series FRM, Footwell Module Repair

DescriptionE Series FRM3 module (Footwell Module) is used on:
BMW E81, E82, E84, E87, E89, E90, E91, E92, E93, E70, E71, E72 series
and Mini R55, R56, R57, R58, R59, R60, R61 series
FRM has three connectors,
Two 51-pin connectors connect the main wiring harness.
Another 26-pin connector is for the connection to the dashboard.

FRM, Footwell Module is responsible for:

Problem
FRM3 can fail when jumpstarting, when coding/programming, or even when reading codes with dealer equipment.
Symptoms of failed Footwell Module are:
Solution
We fix them, fixed/revived footwell modules by us are "Plug&Play"
Which means no additional coding or programming is needed.
FRM3 is located on the right side of the pedals, behind the plastic cover. It has three connectors.
One connector is from the door side, and two connectors are on the back, from the firewall side.
Attention:
* If you do not experience the symptoms described above, it's not a typical FRM3 failure, so please get in touch with us first.
Attention: Please do not place an order if you have FRMFA or FRMII Footwell modules (written on the label)

DescriptionE Series FRM3 module (Footwell Module) is used on:
BMW E81, E82, E84, E87, E89, E90, E91, E92, E93, E70, E71, E72 series
and Mini R55, R56, R57, R58, R59, R60, R61 series
FRM has three connectors,
Two 51-pin connectors connect the main wiring harness.
Another 26-pin connector is for the connection to the dashboard.

FRM, Footwell Module is responsible for:
- Headlight
- Taillights
- Fog lights
- Front courtesy lighting
- Rear courtesy lighting
- Number-plate light
- Power windows
- Exterior mirrors
- Two stepper motor controllers, aka adaptive headlight stepper motors
- Two belt feeder controllers

Problem
FRM3 can fail when jumpstarting, when coding/programming, or even when reading codes with dealer equipment.
Symptoms of failed Footwell Module are:
- Light switches do not work
- Windows do not go up or down
- Few lights like parking lights are constantly on
- Turn lights do not work
Solution
We fix them, fixed/revived footwell modules by us are "Plug&Play"
Which means no additional coding or programming is needed.
FRM3 is located on the right side of the pedals, behind the plastic cover. It has three connectors.
One connector is from the door side, and two connectors are on the back, from the firewall side.
Attention:
* If you do not experience the symptoms described above, it's not a typical FRM3 failure, so please get in touch with us first.
Attention: Please do not place an order if you have FRMFA or FRMII Footwell modules (written on the label)
Please note we only repair the FRM3 module if not damaged in anyway by tampering burning or water damage.
if you have any other faulty module and its not an FRM3 we don’t do it.
you may require this unit to be coded in if the chip is corrupted which we charge a further £150 to carry out
if you have any other faulty module and its not an FRM3 we don’t do it.
you may require this unit to be coded in if the chip is corrupted which we charge a further £150 to carry out